PA6 & PA66

Akulon® Fuel Lock

EPA-conforme oplossingen

Meest populaire Akulon® Fuel Lock Grades

Low fuel permeation PA6 suitable for use in blow molding

Durethan® FLE40-HP

Durethan® is the trade name for our range of engineering thermoplastics based on polyamide 6 and polyamide 66. These polyamides are partially crystalline thermoplastics which offer an ideal combination of properties, especially for technical applications. They provide high mechanical strength and stiffness, good dielectric properties, high resistance to both heat and chemical attack, and good friction and wear properties.

check_circle
Low fuel permeation PA6 suitable for use in blow molding

Envalior Plasticsfinder

Low fuel permeation PA6 suitable for use in injection molding/welding of small engine fuel tanks

Durethan® FLE-LP 000000

Durethan® is the trade name for our range of engineering thermoplastics based on polyamide 6 and polyamide 66. These polyamides are partially crystalline thermoplastics which offer an ideal combination of properties, especially for technical applications. They provide high mechanical strength and stiffness, good dielectric properties, high resistance to both heat and chemical attack, and good friction and wear properties.

check_circle
Low fuel permeation PA6 suitable for use in injection molding/welding of small engine fuel tanks

Envalior Plasticsfinder

Aanbevolen applicaties

Hydrogen pressure vessel

Automotive | Engine | Fuel System

70% lighter than conventional steel tanks ; Cost-effective solution due to excellent processability ;High impact resistance and high elongation down t...

Lees meereast

Laden...

Outdoor power product fuel tanks

Consumer goods | Lawn & garden

Increased design freedom (minimum wall thickness possible up to 1.2mm) ;Evaporative emissions barrier more than six times higher than regulations requ...